Plate Heat Exchanger NORDIC Ba-16-12 1" 50kW

Heat Exchanger  - Nordic Tec Ba-16-12 - 4x 1", 12 plates

50 kW heat exchanger for connecting new circuits, such as glycol circuits, to heating systems

More parameters - Heat Exchanger Ba-16-12

Heat Exchanger 50 kW - Nominal Power

✅ The Ba-16-12 is a 50 kW heat exchanger (nominal power). We would like to emphasize that the nominal power in this case represents the maximum power that can be achieved under very high supply parameters (so-called industrial parameters). This does not correspond to the power of the furnace, boiler, or heating device for which this heat exchanger is used. In practice, it is intended for small heating devices.

If you encounter any difficulties in selecting the right model, please contact our support service.

Plate surface of the Ba-16-12 heat exchanger

As shown in the graph, the Ba-16-12 heat exchanger is the smallest model in the Ba-16 series and also the smallest model with a 1" connection in our catalog. With a plate surface of 0.19 m², its capabilities are naturally limited: it is not used for fully heating single-family homes but rather for specific sections of heating systems. It is typically used for special applications, such as adding additional heating circuits (including glycol circuits) to existing systems.

If you are looking for a heat exchanger with a larger plate surface while maintaining the 1-inch connection, check out the larger models visible in the graph, such as the Ba-16-24 or Ba-16-34.

Dimensions - Small Heat Exchanger Ba-16-12:

(A) - 220 mm
(B) - 90 mm
(F) - 33 mm
(C) - 180 mm
(D) - 52 mm

__________________________________

Brazed Plate Heat Exchanger Ba-16-12 by Nordic Tec - description:

This is the smallest exchanger in the manufacturer's offer among exchangers with connections 1". It works in systems where a large heat exchange area is not needed, while an important factor is the possibility of using a relatively high flow level. The nominal capacity of the device is up to 8 m3/h. An example of using an additional circuit to an existing installation per 1", e.g. a circulation flooded with glycol, such as an additional garage or an outbuilding - assuming that we do not want to narrow the installation on the warm side by installing the exchanger with 3/4". The unusuality of the Ba-16-12 model consists in connecting 1 inch connections (characteristic of larger models) with a relatively small thermal transfer surface - 0.192 m². Although mathematically, it is small, it will easily heat, for example, an outbuilding with a size of 60-100m².

If you have questions or would like to verify the selection of a heat exchanger - we invite you to the "Contact" tab