Heating Manifold for Central Heating systems dedicated especially for 10 circuits
D = 675mm
Technical details:
|
Material
Pressure
PEX Connections'
Supply conenctions / Ball-valves dimensions
Maximum working temperature:
|
Brass Ms58, Chrome-Plated
Recommanded <6bar, Tested with 10 bar
3/4", DN20
1", DN25
<90 °C
|
Nordic Tec UFH heating manifolds 10 ports:
After heat exchangers, the second most recognizable product of the brand, in this case a manifold intended for 10 heating circuits. Due to the fact that it has rotameters, i.e. float flow meters for each section - it is dedicated mainly to surface / floor heating (where flow measurement seems to be particularly important). Nevertheless - there are no technical contraindications for use also with traditional radiator heating, because it has been tested under pressure conditions up to 10 bar (the recommended value of the working pressure of the manifold is 6 bar).
The manifold, as a component of the central heating system, has the task of efficient and controlled distribution of the heating medium into individual sections, so that we can have full control over this process. Thanks to this, we can gain the possibility of full temperature control in individual rooms, as long as we properly plan the arrangement of heating loops in our system.
The device has as standard thermoregulatory valves or simply cocks that can be used to partially or fully close a given heating circuit. You can unscrew them and replace them with electric actuators in order to automate the process. The manifold has been designed in such a way that there is no problem with finding the actuators in any country of Europe - they are intended for the most common thread M30x1.5, that is to sum up - the actuator can be found in almost any brand, practically in every country.
The above product can be found in our store in versions from 2 to 12 sections.
